TDSL 16000 - Upstream FULL - Downstream NICHT (wie 6mBiT)
Hi,
ich habe seit kurzem TDSL 16mBit (vorher 6mBit) !!!!
Mein Router (Speedport W501V) erkennt es auch perfekt:
Hier ein Speedtest:
UPSTREAM: 1.327 kbit/s (166 kByte/s)
DOWNSTREAM: 5.578 kbit/s (697 kByte/s)
>> UPSTREAM wie gesagt MEHR ALS OK - DOWNSTREAM allerdings nur wie bei 6mBit !!!!
Woran kann das liegen, denn der Router erkennt ja die volle Geschwindigkeit
Hier noch eine Analyse:
Zitat:
TCP options string = 020405ac0103030301010402
MTU = 1492
MTU is optimized for PPoE DSL broadband. If not, consider raising MTU to 1500 for optimal throughput.
MSS = 1452
MSS is optimized for PPPoE DSL broadband. If not, consider raising your MTU value.
Default TCP Receive Window (RWIN) = 522720
RWIN Scaling (RFC1323) = 3 bits (scale factor of 6)
Unscaled TCP Receive Window = 65340
RWIN is a multiple of MSS
Other RWIN values that might work well with your current MTU/MSS:
511104 (MSS x 44 * scale factor of 8)
255552 (MSS x 44 * scale factor of 4)
127776 (MSS x 44 * scale factor of 2)
63888 (MSS x 44)
bandwidth * delay product (Note this is not a speed test):
Your TCP Window limits you to: 20908.8 kbps (2613.6 KBytes/s) @ 200ms
Your TCP Window limits you to: 8363.52 kbps (1045.44 KBytes/s) @ 500ms
MTU Discovery (RFC1191) = ON
Time to live left = 57 hops
TTL value is ok.
Timestamps (RFC1323) = OFF
Selective Acknowledgements (RFC2018) = ON
IP type of service field (RFC1349) = 00010000 (16)
Precedence (priority) = 000 (routine)
Delay = 1 (low delay)
Throughput = 0 (normal throughput)
Reliability = 0 (normal reliability)
Cost = 0 (normal cost)
Check bit = 0 (correct, 8th checking bit must be zero)
DiffServ (RFC 2474) = No valid DiffServ equivalent. See the TCP Optimizer documentation, or RFCs 2474, 2475, 2597, 2598, 2873.
Habe beides durchgeführt - bewirkt allerdings keine Änderungen.
Laut Analyse hat sich nur der RWIN-Wert geändert:
Zitat:
TCP options string = 020405ac0103030401010402
MTU = 1492
MTU is optimized for PPoE DSL broadband. If not, consider raising MTU to 1500 for optimal throughput.
MSS = 1452
MSS is optimized for PPPoE DSL broadband. If not, consider raising your MTU value.
Default TCP Receive Window (RWIN) = 1045440
RWIN Scaling (RFC1323) = 4 bits (scale factor of 8)
Unscaled TCP Receive Window = 65340
RWIN is a multiple of MSS
Other RWIN values that might work well with your current MTU/MSS:
511104 (MSS x 44 * scale factor of 8)
255552 (MSS x 44 * scale factor of 4)
127776 (MSS x 44 * scale factor of 2)
63888 (MSS x 44)
bandwidth * delay product (Note this is not a speed test):
Your TCP Window limits you to: 41817.6 kbps (5227.2 KBytes/s) @ 200ms
Your TCP Window limits you to: 16727.04 kbps (2090.88 KBytes/s) @ 500ms
MTU Discovery (RFC1191) = ON
Time to live left = 57 hops
TTL value is ok.
Timestamps (RFC1323) = OFF
Selective Acknowledgements (RFC2018) = ON
IP type of service field (RFC1349) = 00010000 (16)
Precedence (priority) = 000 (routine)
Delay = 1 (low delay)
Throughput = 0 (normal throughput)
Reliability = 0 (normal reliability)
Cost = 0 (normal cost)
Check bit = 0 (correct, 8th checking bit must be zero)
DiffServ (RFC 2474) = No valid DiffServ equivalent. See the TCP Optimizer documentation, or RFCs 2474, 2475, 2597, 2598, 2873.
Per LAN-Verbdinung pendelt er sich bei ca. 1,65 MB/s ein !!!!
Per WLAN-Verbidung sind es wieder höchstens 620 KB/s !!!!
----
Nun habe ich 2 Fragen:
1. Sind die erreichten 1,65 MB/s per LAN wohl das Maximum was ich rausholen kann (wegen Dämpfung, andere Verluste, etc.) ????
2. Irgendetwas muss das WLAN abbremsen - kannst du dir da was genaueres vorstellen ????
Zusammenfassung stimmt nicht ganz - der Router steht ein Stockwert tiefer.
Also eine Wand dazwischen.
Beide Rechner haben den selben WLAN-Adapter !!!! Exakt den selben und gleich konfiguriert !!!!
Damals bei 6mBit hatten ja auch beide Rechner FULL SPEED - nur jetzt bei 16mBit nicht mehr.
Funktelefone stehen in beiden Räumen - insofern sollte das keine Rolle spielen.
Andere Störer fallen mir jetzt nicht ein.
Der Router steht genau unter mir - also nur eine Deckewand - mehr nicht !!!!
Das die Funktelefon stören ist mir auch bewusst, ich wollte damit nur aussagen,
da sie bei beiden Rechner stehen - sollte das nichts mit dem schlechten Speed zu tun haben - da beide Rechner unter diese Störung "leiden".
Hmmmm....echt komisch - verstehe auch nicht warum der UPLOAD VOLLE PULLE läuft- und DOWNLOAD maximal 1/3
werde heute mal zu meinem Kollegen gehen, der hat ja das gleiche problem.. vielleicht bekommen wir etwas raus. evtl. gehts ja gleich mit meinem Notebook FULLSpeed ?!
also das ist herausgekommen beim TEST über WLAN , Fritzbox 7170 neuste Firmware unten, Notebook und PC im1.Stock
ohne TCPoptimizer: ich (Notebook) so an die 9000kbits; kollege um die 6000-8000
nach TCPoptimizer: ich 14162 (um die 14000, min 11000); kollege um die 9000
mitm LAN kabel kam auch nicht mehr als 14600 raus
getestet wurde mit WIEISTMEINEIP.de/speedtest und netcologne/speedtest 100mb datei
wobei die Werte mit Firefox HÖHER sind als InternetExplorer